From the side, the X7 is a long, tall stretch of door and paint, and the factory side skirts do little to break it up. The SQ-Aero Dry Carbon Fiber Side Skirt Extension Set adds a carbon blade along the bottom of each side skirt, so the car sits visually lower and looks longer between the wheels.
Both extensions are pre-preg dry carbon fiber with a gloss clear coat, not a wrap, vinyl film or hydro-dipped plastic. The set fits the factory side skirts on the 2019-2027 G07 X7, Pre-LCI and LCI, with or without the M Sport package.
Dry Carbon Fiber Side Skirt Extensions for the BMW G07 X7
Each extension mounts to the lower part of the factory side skirt, and the factory skirts stay on the car. That keeps the install simpler than a full skirt replacement and leaves your factory parts untouched.
Pre-preg carbon is cured under heat and pressure, so it comes out lighter and stiffer than wet-lay carbon and the weave stays consistent from side to side. On an X7, the side skirts take a lot of road spray, and the gloss clear coat protects the carbon from UV and grime.
For a matching carbon lower body, pair it with the SQ-Aero rear diffuser set and, on 2023-2027 LCI cars, the SQ-Aero front lip set. Both of those are made for M Sport bumpers only.
What's Included
- 2 x SQ-Aero dry carbon fiber side skirt extensions (left and right)
Key Features
- 100% pre-preg dry carbon fiber, not a wrap or vinyl film
- Gloss clear coat finish with UV protection
- Mounts to the lower part of the factory side skirts, no skirt replacement needed
- Fits Pre-LCI and LCI G07 X7, with or without M Sport
Vehicle Fitment
Fits US-market BMW G07 X7 models, with or without the M Sport package:
- G07 X7 Pre-LCI (2019-2022): xDrive40i, M50i
- G07 X7 LCI (2023-2027): xDrive40i, M60i
Part number: SQ-008
Installation Notes
Professional installation is recommended. Each extension runs most of the length of the car, so line it up carefully before it goes on.
- Clean the lower edge of both factory side skirts with isopropyl alcohol and let them dry fully.
- Test-fit each extension and check the gaps from the front wheel arch to the rear before mounting anything.
- Mount each extension with the supplied hardware, following the factory skirt line.
- Recheck the fit and alignment on both sides after a short drive.
