MMX Performance Rear Differential Raised Poly Bush - BMW G87 M2 / G80 M3 / G82 M4

Regular price $159.95

Black Friday price: $151.95 (applied in cart)

SKU: MMR55-1605

Add To Wishlist

Lowering a G8X changes the angle the axle shafts run at, and that angle turns into heat and early wear in the CV joints. The factory rubber diff bush also lets the differential move around under hard acceleration.

The MMX rear differential raised poly bush fixes both, with one part that works at factory height or raised 10mm.

Raised Poly Bush With Two Positions

At OEM height, the polyurethane bush gives a more controlled connection between the diff and chassis, reducing movement under changing loads. On lowered cars, set the center section to +10mm to raise the rear diff mount and restore driveshaft geometry, reducing operating angle, heat, and premature axle and CV wear.

Build a 3-Point or 4-Point System

Pair it with the MMX front cradle mount (MMR55-1604) for a 3-point setup, or use two bushes with the MMX dual differential mount (MMR55-1606) for a full 4-point system.

What's Included

  • MMR55-1605: (1) bush for the OEM rear differential mount
  • MMR55-1605KT: (2) bushes for the MMX dual differential mount

Key Features

  • OEM-height and +10mm raised settings
  • Polyurethane construction for more diff control
  • Designed for minimal NVH increase, road and track use
  • Installs in the existing mount location without modification
  • Works with OEM and aftermarket axle shafts

Vehicle Fitment

Fits the following BMW models:

  • BMW G80 M3 (2021-2026)
  • BMW G81 M3 Touring (2023-2026)
  • BMW G82 M4 (2021-2026)
  • BMW G83 M4 Convertible (2022-2026)
  • BMW G87 M2 (2023-2026)

G8X only. Not used on F8X cars.

Installation Notes

Pressing out the factory bush requires a press or bush tool. Professional installation is recommended.

  1. Lift the car and support the rear differential.
  2. Remove the rear differential mount and press out the factory bush.
  3. Install the MMX bush in your chosen OEM or +10mm position.
  4. Reinstall the mount and torque all fasteners to specification.