MMX Performance 5x120 Hubcentric Wheel Spacer Kit - BMW M14x1.25 / 72.6mm Bore

Regular price $122.78

Black Friday price: $116.64 (applied in cart)

SKU: MMR37-1512

Add To Wishlist

Most F-series BMWs leave the factory with the wheels tucked well inside the arches, and the car looks narrower than it should.

The MMX 5x120 wheel spacer kit pushes the wheels out to close that gap and widen the track, on hardware built for the job.

Hubcentric Wheel Spacers, Not Bolt-Centric

This is the part that matters most. Each spacer has a machined alloy spigot that centers it on the hub and keeps the OE 72.6mm center bore, so the wheel is located by the hub, not by the bolts. That makes it easier to fit and stops it introducing vibration. Non-hubcentric spacers are a bad idea on a performance car for exactly that reason.

Clearance as Well as Stance

Beyond the look, the extra offset is often what creates room for a big brake kit, coilovers, or a wider wheel and tire. Each pair is machined from 7075-T6 aerospace aluminum, anodized against corrosion, and comes with ten extended M14x1.25 black wheel bolts matched to the spacer thickness, so thread engagement into the hub stays correct.

What's Included

  • (2) MMX hubcentric wheel spacers in your selected thickness, one axle set
  • (10) Extended M14x1.25 black wheel bolts matched to the spacer thickness

Key Features

  • Sold in pairs, one axle set
  • 12mm (MMR37-1512), 15mm (MMR37-1515), or 18mm (MMR37-1518)
  • 7075-T6 aerospace aluminum, anodized
  • Hubcentric with a machined alloy spigot
  • 72.6mm center bore retained for factory or aftermarket wheels
  • 1-year manufacturer warranty, designed and tested in the UK

Vehicle Fitment

Fits BMW models with all three of these hub specifications:

  • 5x120 bolt pattern
  • 72.6mm hub bore
  • M14x1.25 wheel bolts

Confirm your car uses this hub before ordering, and contact us if you are not sure. This item is non-returnable.

Installation Notes

Professional installation is recommended. Always use the supplied extended bolts with these spacers. Clean anodized parts with mild soap and water only. Acidic or alkaline wheel cleaners, solvents, abrasives, and harsh car wash chemicals such as traffic film remover will damage the finish.

  1. Lift the car, support it safely, and remove the wheel.
  2. Clean the hub face and the back of the wheel, then check the spacer sits flat against both.
  3. Fit the spacer, mount the wheel with the supplied extended bolts, and torque to the BMW specification.
  4. Check arch clearance at full left and full right lock, and re-check bolt torque after the first 50 miles.