Amber side markers on a blacked-out G-Wagon are a contradiction. The rest of the truck commands attention. Those orange strips apologize for it.
This smoked side marker reflector set replaces the factory amber front and red rear reflectors on the W463A and W465 G-Class with dark smoke-tinted units that actually belong on the build around them. Four pieces, OEM-spec fitment, flush in the factory channels. No drilling, no wiring, no modifications.
Smoked G-Wagon Side Marker Reflectors
The factory amber front and red rear reflectors were designed to be visible. That is the problem. On a Night Package build, a full blackout, or a G63 with dark trim, they break the exterior with color that does not belong. This set swaps them for dark smoked units that disappear into the body line. The way everything else on a properly built G-Wagon does.
What's Included
- 2 smoked front reflector strips
- 2 smoked rear reflector strips
- Complete 4-piece set, direct OEM-replacement fitment
Key Features
- Smoked finish replaces factory amber front and red rear strips
- Flush OEM-spec fit in factory channels, no drilling or wiring required
- Fits W463A G-Class (2019-2024) and W465 G-Class (2025-present): G500, G550, G63 AMG
- Pairs cleanly with Night Package, full blackout builds, and AMG exterior packages
Vehicle Fitment
Fits the following Mercedes-Benz G-Class models:
- W463A G-Class (2019-2024): G500, G550, G63 AMG
- W465 G-Class (2025-present): G500, G550, G63 AMG
Not sure which chassis you have? Check your door jamb sticker or VIN decode for your chassis code before ordering.
Installation Notes
Professional installation is strongly recommended. The factory reflectors are thin, tightly adhesive-bonded strips. They will crack during removal if pulled without heat.
- Use a heat gun to warm the factory reflector and the adhesive beneath it before removal. Work slowly and evenly.
- Remove all adhesive residue from the mounting channels before installing the new pieces.
- Each reflector is labeled FRONT or REAR. Do not swap them.
- Peel, align, and press firmly. Hold each piece for a minimum of 30 seconds to ensure bonding.
