On the S65 V8 M3 models, the stock exhaust headers flow very well, while the catalysts present the largest obstacle and power loss. the Macht Schnell Bypass Track Pipes were designed specifically for race/track use and offer a cost-effective means of removing the 400 cell restrictive primary catalytic converters on all 2008-2013 M3s. Bypass Track Pipes allow you to make two single cuts to your stock mid-pipe section, removing the catalytic converters and clamping the largest diameter straight pipe in their place using the provided high-end/premium exhaust clamps. This eliminates the largest source of exhaust restriction, unleashing considerable power gains (~20hp) and a very obvious improvement in acceleration.
Macht Schnell Bypass Track Pipes permit you to retain your OEM secondary cats and resonators, keeping noise levels tame enough for even the most stringent sound limitations found at many track events (nearly stock decibel levels) and also keeping costs to a minimum. No welding is required for installation, simply cut and bolt into place using supplied exhaust clamps.
Aftermarket software is required to prevent the Check Engine light from illuminating.
Bypass Track Pipe Features:
- Full Stainless Steel Construction, with mandrel, bends for optimum flow
- Straight shot design for zero restriction and high velocity
- Gains as high as 20hp/20lb-ft TQ with no aftermarket software
- Retains OEM O2 locations
- Retains use of OEM crush gaskets
WARNING: Please note that certain aftermarket exhaust systems may not comply with applicable US (including California) laws and regulations and may therefore be prohibited for use on highways, roads, or vehicles otherwise subject to emissions control requirements. California prohibits the use of any aftermarket exhaust system that modifies, removes, or replaces original equipment catalysts unless CARB has issued an Executive Order as to such part or system.
Macht Schnell parts or exhaust systems/components used or intended for use on “racing vehicles” (i.e., a competition vehicle used exclusively for competition on closed-course circuits) do not require an exemption or Executive Order from CARB to be sold in California. However, such parts are prohibited from being used on California public highways or roads, even if occasionally used “off-road.”
Models Supported:
2008-2013 E9X M3