The first time you run harnesses on track in an E92 M3, you realize how much the factory seat belt lets you slide around. The Fall-Line Motorsports Bolt-In Harness Bar gives you a proper harness anchor and rollover protection behind the front seats, without cutting or welding your car.
Fall-Line has been building BMW race cars for more than 15 years, and their bars have been in M cars since the E36 M3.
E92 M3 Bolt-In Harness Bar Construction
The bar is mandrel bent from 1.75 inch x 0.083 inch wall chromoly tubing and fully TIG welded. This is the GTS design, a clean bar with no gussets. Custom paint finishes are available on request. Each bar is a special-order item, made in the USA.
What's Included
- 1 x Fall-Line Motorsports bolt-in harness bar, GTS style (FLM-E92-RB-GTS)
Key Features
- 1.75 x 0.083 inch chromoly tubing, mandrel bent
- Fully TIG welded
- Bolt-in design, no permanent chassis modification
- Harness mounting points for track use
- Made in the USA, special order
- Part number: FLM-E92-RB-GTS
Vehicle Fitment
Fits the following model:
- BMW E92 M3 Coupe (2008-2013)
Installation Notes
Rear seat removal is required. Professional installation is recommended. This bar may not comply with all race sanctioning bodies and technical regulations, so check your series rules before you order. Lead time applies as a special-order item.
- Remove the rear seat and interior trim at the mounting points.
- Position the bar and mark the mounting locations.
- Bolt the bar in with backing plates and torque all hardware.
- Mount harnesses to the bar per the harness manufacturer instructions.
