You put a Dinan carbon fiber intake on your X5M or X6M because you wanted the turbos breathing freely. A tired, dirty filter quietly takes that away. When it is time for service, put back exactly what Dinan designed the system around.
This Dinan Replacement Air Filter is the correct filter for the Dinan carbon fiber cold air intake on the BMW F95 X5M and F96 X6M. It is the same deep-pleated, multi-layer cotton filter that ships in the intake kit, with custom-molded ends that seal into the Dinan airbox. Generic filters are not made to this shape, and a poor seal lets unfiltered air reach the turbos.
Why Use a Genuine Dinan Replacement Air Filter
Deep pleats in multi-layer cotton give the filter a large working surface for flow and filtration. A steel wire mesh supports the media so it holds its shape and resists dents, and the molded ends make full use of the filter area inside the enlarged Dinan airbox. It fits exactly the way the original did, so there is no guesswork and no modification.
How Many Replacement Air Filters Do You Need?
This filter is sold individually. The Dinan intake runs one filter on each side of the engine, so order a quantity of two to service both sides at once. It also fits the Dinan carbon fiber intake for the BMW 540i, 740i and 840i, and the Dinan intake on the X5, X6 and X7 M60i. Dinan part number D401-0030. Sold by AutoTecknic, an authorized Dinan dealer.
What's Included
- One Dinan replacement air filter
Key Features
- Correct replacement filter for Dinan intakes D760-0056 and D760-0068
- Deep-pleated multi-layer cotton media
- Steel wire mesh for strength and dent resistance
- Custom-molded ends seal into the Dinan airbox
- Direct replacement, no modification
- Sold individually, two needed per car
Vehicle Fitment
Fits vehicles equipped with the Dinan carbon fiber cold air intake D760-0056 or D760-0068:
- BMW X5M / F95 (2020-2023): X5M, X5M Competition
- BMW X6M / F96 (2020-2023): X6M, X6M Competition
- BMW X5 M60i / G05, X6 M60i / G06 and X7 M60i / G07 (2023-2026)
- BMW 540i, 740i and 840i with Dinan intake D760-0068 (2017-2026)
This filter does not fit the factory airbox. It is for cars already running the Dinan intake.
Installation Notes
Filter replacement takes a few minutes per side with basic hand tools. Cover the turbo inlets while the airbox is open so nothing falls inside.
- Remove the Dinan airbox lid or access cover on one side.
- Loosen the clamp and remove the old filter.
- Install the new Dinan filter and tighten the clamp evenly.
- Refit the airbox lid, then repeat on the other side.
