Fifteen millimeters is the size where a G-chassis BMW stops looking like it rolled off the dealer lot. The tire moves from tucked inside the arch to sitting right under the fender lip, and the car looks planted from every angle.
Dinan 15mm wheel spacers (part number D210-2029) are machined for the BMW 5x112 bolt pattern and 66.5mm center bore used across the G-chassis lineup. Each spacer moves the wheel 15mm further from the hub, widening your track for a fuller stance and more room around big brake calipers. You get a pair, enough for one axle.
Why Dinan 15mm Wheel Spacers Are Worth It
A spacer that does not center on the hub shows up as a shimmy at highway speed. These are CNC-machined from billet 6061 aluminum and anodized black, with a 66.5mm bore cut to BMW's G-chassis hub diameter. Dinan lists hub-centric rings on its larger spacer sizes, so the wheel is located by the hub and not by the bolts.
The real question with any spacer is bolts. Your factory wheel bolts are sized for wheel-to-hub contact only. Add 15mm and you need bolts long enough to keep full thread engagement. Dinan calls out its 45mm M14x1.25 cone seat lug bolts for this spacer, so there is no guessing. Order them together and you are ready to bolt up.
What's Included
- 2 x Dinan 15mm wheel spacers, 5x112, 66.5mm center bore
Lug bolts are not included. Dinan's matching bolt for this spacer is the M14x1.25 cone seat 45mm set of 10 (sold separately).
Key Features
- 15mm thickness moves each wheel 15mm outboard
- 5x112 bolt pattern with 66.5mm center bore for BMW G-chassis hubs
- CNC-machined billet 6061 aluminum
- Weight-saving design
- Black anodized finish
- Sold as a pair (one axle)
- Designed to pair with Dinan 45mm M14x1.25 cone seat lug bolts
Vehicle Fitment
Dinan specifies this spacer by chassis family, not by individual model:
- BMW G-Chassis: 5x112 bolt pattern, 66.5mm center bore, M14x1.25 lug bolts
- Dinan-listed exceptions that also use this G-chassis fitment: F90 M5, F91 / F92 / F93 M8, F48 X1, F39 X2
Not for E-chassis or 5x120 F-chassis BMWs. If your car is not a G-chassis model or one of the exceptions above, contact us before ordering.
Installation Notes
A bolt-on job with a jack, jack stands and a torque wrench. The one step you cannot skip is longer bolts: Dinan matches its 45mm M14x1.25 cone seat bolts to this spacer. At 15mm the wheel moves out a meaningful amount, so check tire-to-fender clearance at full steering lock and full compression, especially on staggered or aggressive-offset setups.
- Loosen the wheel bolts, raise the car and support it on jack stands.
- Remove the wheel and clean any rust or debris from the hub face.
- Slide the spacer over the hub pilot so it sits flush against the hub face.
- Mount the wheel and thread in the 45mm lug bolts by hand.
- Snug the bolts in a star pattern, lower the car and torque to your BMW's factory wheel bolt specification.
- Recheck torque after the first short drive.
