The RS3 8V is already a sharp car, and a proper coilover setup pushes it further. But when those aftermarket dampers replace the factory EDC units, the Electronic Damping Control module loses its signal and responds with fault codes that show up every time the car wakes up. That is not a situation you want in a car you drove specifically because of how it performs.
The KW EDC Cancellation Kit eliminates those codes at the source. It connects to the existing EDC harness and sends a simulated signal that the factory module accepts as normal OEM output. Dash warnings clear, the fault log stays clean, and every other system tied to the RS3's electronics, including ESP and traction control, keeps running exactly as intended.
Key Features
- Eliminates EDC fault codes when using aftermarket coilovers on the Audi RS3 8V
- Plug-and-play design connects directly to the existing EDC wiring harness
- Simulates OEM adaptive damper signal to the factory Electronic Damping Control module
- Preserves full ESP, traction control, and driver assistance system operation
- Required for all aftermarket coilover installations on EDC-equipped Audi RS3 8V
Vehicle Fitment
Required for aftermarket coilover installations on EDC-equipped:
- Audi RS3 Type 8V (2017-2020): All variants equipped with factory Electronic Damping Control
Installation Notes
Plug-and-play installation. No coding or module reprogramming required.
- Confirm your RS3 8V is equipped with EDC before ordering. All RS3 variants include EDC as standard equipment
- Install aftermarket coilovers per manufacturer instructions
- Connect cancellation kit to existing EDC harness connectors
- Clear any stored fault codes after installation