Your X6M's stance should be your call, not a compromise baked into a fixed spring. A touch lower for a clean daily look, or tucked for the meet. With VTF you decide, and you can change your mind later.
H&R VTF Adjustable Lowering Springs are F86 X6M adjustable lowering springs with height-adjustable perches: 1.4 to 2.2 inches lower in front and 1.2 to 2.0 inches lower in the rear, per H&R's published range for this car. VTF stands for Verstellbare TieferlegungsFedern, German for adjustable lowering springs.
F86 X6M Adjustable Lowering Springs for Factory Electronic Dampers
Coilovers delete the X6M's factory electronic dampers and the drive modes built around them. VTF keeps them. H&R designed these springs specifically to work with the original electronic shocks, so you keep the comfort-to-sport range BMW engineered while gaining real ride height control. It is the adjustable stance option that does not turn your daily driver into a project.
Each VTF spring is made in Germany by H&R from high tensile spring steel and tested in an ISO 9001 certified facility. Sold by AutoTecknic, an authorized H&R dealer.
What's Included
- H&R VTF Adjustable Lowering Spring kit, part number 23008-1
- H&R precision adjustment collars and spring perches
Key Features
- Adjustable lowering of 1.4-2.2 in. front and 1.2-2.0 in. rear (H&R published range)
- Designed to work with the factory electronic dampers and drive modes
- Precision adjustment collars for fine, even corner-to-corner height tuning
- Made in Germany in an ISO 9001 certified facility, TUV approved
Vehicle Fitment
This H&R kit fits the following US-market vehicle:
- BMW X6M / F86 (2015-2019): all US models
Installation Notes
Professional installation is strongly recommended. A spring compressor is required, and the adjustable perches are set to your target ride height during installation, so decide on your stance before the car goes on the lift. A four-wheel alignment is required after installation and after any later height change.
- Measure and record your current fender-to-hub heights at all four corners.
- Raise and securely support the vehicle, then remove the wheels and suspension assemblies per H&R's instructions.
- Use a spring compressor to fit the H&R VTF springs and adjustable perches, setting each perch to your chosen height within H&R's published range.
- Reinstall, torque fasteners at ride height, then measure again and fine-tune the perches until side-to-side heights match.
- Let the springs settle, recheck heights, and finish with a full four-wheel alignment.
