Lower an M car and the rear sway bar is no longer sitting neutral. It preloads one side, upsets corner weights and makes the car behave differently turning left versus right. The Fall-Line Motorsports Adjustable Rear Sway Bar End Link Kit V2 lets you set the bar unloaded at your ride height, so the chassis is balanced again.
Essential if you run height-adjustable coilovers or plan to corner balance.
V2 End Links with Pinch-Nut Rod Ends
Each link is length adjustable. The V2 design uses OE tie-rod style pinch-nut rod ends instead of jam nuts, which can creep and lose their set length. Dust boots protect the joints. On G8X cars, the link's lower ball joint replaces the factory bushing and pass-through bolt. Made in the USA.
What's Included
- 2 x adjustable rear sway bar end links with dust boots
Key Features
- Length adjustable to remove sway bar preload
- Pinch-nut rod ends hold their set length
- Improves corner balance and cross-weights
- Works with height-adjustable coilovers
- Made in the USA
- Part number: FLM-F8X-G8X-1BRLINK
Vehicle Fitment
Fits the following models:
- BMW F80 M3 Sedan (2015-2018)
- BMW F82 / F83 M4 (2015-2020)
- BMW F87 M2 / M2 Competition (2016-2021)
- BMW G80 M3 Sedan (2021-2026)
- BMW G82 / G83 M4 (2021-2026)
- BMW G87 M2 (2023-2026)
Installation Notes
Set link length with the car at operating weight on its wheels or on ramps.
- Remove the factory rear sway bar end links.
- Install the Fall-Line links loosely.
- With the car at ride height and driver weight, adjust each link until the bar is unloaded.
- Tighten the pinch-nuts and torque all hardware.
