H&R Sport Spring Kit - BMW E92 328i Coupe RWD (2007-2013)

Sale price $330.65 Regular price $389.00

Black Friday price: $314.12 (applied in cart)

SKU: 50490-2

Add To Wishlist

The E92 328i coupe has one of the best-looking BMW profiles of its era, and it looks even better once the fender gap is gone. H&R Sport Springs lower the E92 328i Coupe and cut body roll, and they work with your factory shocks.

On the E92 328i Coupe, H&R lists about 1.3 in. of drop up front and 1.2 in. at the rear.

Why H&R Sport Springs on the E92 328i Coupe

Sport Springs are H&R's best-selling product. The progressive rate design keeps the ride comfortable over rough pavement, while the lower center of gravity reduces body roll and sharpens turn-in. Every spring is wound from 54SiCr6 spring steel and shot-peened, and H&R builds them not to set or sag over time.

Worried about ride quality? H&R tunes Sport Spring rates for daily street use on the factory shocks. Worn shocks are the bigger risk. Tired dampers struggle to control any lowered spring, so if yours have high miles, replace them at the same time.

What's Included

  • 2 front springs
  • 2 rear springs

Product photo shows a representative H&R kit. Color, shape and packaging vary by application.

Key Features

  • About 1.3 in. front and 1.2 in. rear lowering (H&R figures)
  • Works with the factory shocks, no modifications needed
  • Progressive rate design for a comfortable street ride
  • 54SiCr6 spring steel, shot-peened, built not to set or sag
  • Every spring is tested before it leaves H&R's ISO 9001 certified plant in Germany
  • H&R part number 50490-2
  • Limited lifetime warranty from H&R

Vehicle Fitment

The H&R Sport Spring Kit 50490-2 fits these BMW models:

  • BMW E92 328i Coupe (2007-2013)

Not for xi, xDrive or other all-wheel drive models. Lowering can vary on cars with factory sport suspension. Not sure which version you need? Send us your VIN and we will confirm.

Installation Notes

This is a standard spring swap that a suspension shop can handle in a few hours. If you do it yourself, you need a proper strut spring compressor. Never take a front strut apart without one.

  1. Lift the car and support it on jack stands at the factory lift points.
  2. Remove the front struts, compress the factory springs, and move the top mounts and hardware onto the H&R springs.
  3. Replace the rear springs, following the H&R instructions supplied with the kit.
  4. Tighten the suspension bolts with the car at ride height so the rubber bushings are not preloaded.
  5. Get a four-wheel alignment once the car is back on the ground.