MMX Performance Replacement Wheel Stud Set (20) - BMW / MINI M14x1.25

Regular price $147.00

Black Friday price: $139.65 (applied in cart)

SKU: MMR37-1503-70

Add To Wishlist

Running the MMX stud and nut conversion and need fresh studs, or a different length for a new spacer? This is the service part.

The MMX replacement wheel stud set gives you 20 studs, enough for all four wheels on a five-lug car.

Replacement Wheel Stud Set, Sized by Spacer

Pick the length for the spacer you run. The 70mm stud suits no spacer or up to a 10mm spacer, and the 80mm stud covers 10mm to 20mm. The wrong length either leaves too little thread at the nut or leaves the stud sticking out further than it should.

Same Studs as the Conversion Kit

Each stud threads into the hub in place of the factory bolt and installs with an internal 6mm Allen key, which makes the conversion easy to fit and easy to reverse. They are heat-treated high-carbon steel, chrome plated, with a 13mm threaded hub shank and an 8mm unthreaded section for brake disc clearance. These studs are designed for the MMX kit, not as a replacement for another brand's conversion.

What's Included

  • (20) MMX wheel studs in your selected length
  • Wheel nuts are not included

Key Features

  • Complete set of 20 studs for all four wheels
  • 70mm (MMR37-1503-70) or 80mm (MMR37-1503-80)
  • M14x1.25 thread, internal 6mm Allen drive
  • 13mm threaded hub shank, 8mm unthreaded shank
  • Heat-treated high-carbon steel, chrome plated
  • Maximum approved vehicle weight 2,500kg
  • 1-year manufacturer warranty, designed and tested in the UK

Vehicle Fitment

Fits BMW and MINI models with M14x1.25 wheel hardware running the MMX stud and nut conversion:

  • No spacer, or spacers up to 10mm: 70mm studs (MMR37-1503-70)
  • Spacers from 10mm to 20mm: 80mm studs (MMR37-1503-80)

MMX aluminum wheel nuts are sold separately.

Installation Notes

Follow the MMX stud fitting procedure. Professional installation is recommended.

  1. Remove the wheels. Clean the hub threads and the short end of each stud with brake cleaner so both are free of dirt and grease.
  2. Check that the stud shank passes cleanly through the brake disc holes without bottoming on the disc.
  3. Apply a thin coat of high-temperature threadlocker (Loctite 2422 or equivalent) to the short end, then thread each stud into the hub with a 6mm Allen key until the shank seats, about 30 ft-lbs (40Nm). Do not overtighten.
  4. Let the threadlocker cure for about three hours, fit the wheels, and torque the nuts with a 19mm socket to the factory wheel bolt specification. Re-check torque after about 30 minutes of driving.