Factory mirror caps are painted plastic. These are not. AutoTecknic Version II M-Inspired Dry Carbon Mirror Covers replace the OEM caps on your BMW F30 3-Series, F32 or F36 4-Series, F22 2-Series, F87 M2, F20 1-Series or E84 X1 with a sharper M-inspired profile made from pre-preg dry carbon fiber.
Version II is AutoTecknic's current design, with a different profile from the discontinued Version I. You get a matched driver and passenger pair in 3K 2x2 twill weave with a gloss finish.
Real Pre-Preg Dry Carbon Mirror Covers
Pre-preg means the resin is already in the carbon fabric before it goes into the mold. Each cover is then autoclave cured under uniform heat and pressure, which removes the air pockets and resin voids common in wet carbon layups. The result is a tighter, cleaner weave and a stiffer part.
This is not a vinyl wrap, printed carbon-look film or hydrodip. The weave you see is the part itself, sealed under a protective gloss clear coat.
Direct Replacement for Your OEM Mirror Caps
These covers replace your factory caps at the OEM mounting points instead of taping over them, so there is no added bulk and nothing to cut or trim. Your factory caps come off intact, so you can go back to stock anytime.
What's Included
- 1x driver side dry carbon mirror cover
- 1x passenger side dry carbon mirror cover
Key Features
- Version II M-inspired profile replaces the factory mirror caps
- 100% genuine pre-preg dry carbon fiber, autoclave cured
- Real 3K 2x2 twill weave, not a wrap or film
- Protective gloss clear coat finish
- Mounts at the OEM mounting points, no cutting or trimming
- Sold as a matched driver and passenger pair
Vehicle Fitment
Confirmed fitment, including LCI models:
- BMW F20/F21 1-Series (2012-2019): non-US market models including M135i and M140i
- BMW F22 2-Series Coupe (2014-2021) and F23 2-Series Convertible (2015-2021): including M235i and M240i
- BMW F87 M2 (2016-2018): base M2 only
- BMW F30 3-Series Sedan (2012-2019) and F31 3-Series Sports Wagon (2014-2019)
- BMW F34 3-Series Gran Turismo (2014-2019)
- BMW F32 4-Series Coupe and F33 4-Series Convertible (2014-2020)
- BMW F36 4-Series Gran Coupe (2015-2020)
- BMW E84 X1 (2013-2015)
Not compatible with:
Installation Notes
Most owners install these at home in under 30 minutes with a plastic trim tool. Work slowly. The factory clips are the only thing holding the cap in place, and they are easier to break when cold.
- Fold the mirror and tilt the mirror glass inward to reach the back of the factory cap.
- Release the factory cap clips with a plastic trim tool and pull the cap off.
- Line up the AutoTecknic cover with the OEM mounting points.
- Press evenly around the edge until every clip seats.
- Repeat on the other side and check that the mirror folds and adjusts normally.
